The PV Series union elbow shown here turns an air tube through 90 degrees without using a threaded port. It accepts a tube at each end, and the elbow keeps the line from being forced into a tight bend.
You will often find this style inside control cabinets, packaging machines and compact assembly equipment. It is handy when a tube must pass around a bracket or another component. Instead of bending the tube sharply, the installer can use the elbow to make a clean corner.
Send us the tube outside diameter and the quantity you need. We will compare them with the available PV Series union elbow sizes before preparing a quote.
PV is a common model code for a 90-degree union elbow with push-in tube ports at both ends.
No. The product shown in the photo has two push-in tube ports.
Usually, yes. The standard fitting has the same tube size at both ends. Tell us if a reducing elbow is needed.
First release the air pressure. Hold the release ring down against the fitting, then pull the tube straight out.
